A good rule of thumb is to use a 30 degree blade for films that are in the 1 2 mil range.
What are the blade settings for cutting adhesive vinyl.
Use this mat when cutting fabric.
You can access the cut settings by clicking on the send tab in silhouette studio.
You also want to make sure you have picked cut which will turn on the cut lines.
One of the most common issues from silhouette cameo beginners is that their cameo 3 autoblade is cutting through the vinyl or other material and the backing.
After you make the material type in the send panel the recommended cut settings for vinyl will be displayed.
After the design is cut it is time to weed the vinyl.
Cutting vinyl with a cricut machine.
Select images and size and load the mat into the machine.
Below you ll find cut settings for silhouette cricut and brother scan n cut.
Cut and press settings for products at products cricut setting silhouette setting brother scan cut setting etched vinyl light card stock material.
The tricky news is that each piece of vinyl blade and machine can cut a little differently.
Vinyl matte blade 1 speed 5 force 10 blade 3 speed 3 pressure 2.
Refer to kiss cut guide below to adjust machine settings.
Films like avery dennison beaded or prismatic reflective films are best cut with a 60 degree blade.
You can right click on the images to save them to your computer or you can click the pinterest button in the middle to save them for later.
Card stock plain blade 1 speed 4 force 14 blade 3 speed 3 pressure 3 oracal 631 custom.
That said pressure settings are notoriously fickle from cutter to cutter material to material even different lots of the same vinyl can require slightly different pressure settings.
Verify that the tool is set to autoblade cameo 3 or portrait 2 only or the ratchet blade cameo 1 2 portrait.
Standard cut blade turquoise 4.
Click on blade settings to find all the cut settings you need.
They then pull up the box around the image and continue to weed from.
Cut settings can be easiest and trickiest of getting great cut.
Cut weed and apply the vinyl weed the vinyl.
Use the low tack adhesive mat with copy paper and smooth paper.
Some people prefer to add a weeding box around their image when they cut.
The same goes for the portrait 2 autoblade.
The standard pressure setting for your cutter is 100 for non servo cutters mh sc series laserpoint series titan 1 and 60 for servo cutters titan 2 3.
Place vinyl liner side down onto cricut standardgrip mat.
You can also find a vinyl guide and a sizing guide below.
This is a mat with a high adhesive strength.
You need to make sure you text cut every time you change vinyl to avoid wasting materials.
